Cleaning Vinyl Records With Soap and Water?

Vinyl records are a great way of preserving your music collection, but they can be difficult to clean if you don’t know what you’re doing. 

Cleaning vinyl records with soap and water is one of the easiest ways to keep them in good condition. This guide will show you how. 

It’s also very effective at removing dirt from the surface of the record.

Step by Step Guide to Cleaning Vinyl Records With Soap and Water?

What You Will Need:

To get started, you need some basic supplies like a bottle of rubbing alcohol, a cotton swab, a small container or bowl for soaking the records, and a sponge. If you want to make things easier, you could buy a vinyl cleaner that contains all of these items. However, this isn’t necessary as long as you have everything else on hand.

How to Clean Vinyl Records Using Rubbing Alcohol:

  1. Start by pouring a little bit of rubbing alcohol into a small bowl or container
  2. Dip the cotton swab into the alcohol and rub it over the entire surface of the record. Make sure not to touch the grooves or labels.
  3. Once you’ve finished cleaning the record, wipe off any excess alcohol using a dry cloth.
  4. Repeat steps 1-3 until the record has been cleaned thoroughly.
  5. Now you can put the record away in its sleeve or place it back onto its original platter.
  6. To remove any residue left behind after cleaning, pour more rubbing alcohol into the bowl or container and repeat step 2.
  7. When you’re done, let the record air dry completely before storing it.
  8. If you want to store your vinyl records in their sleeves, you should first wrap each record individually in plastic wrap. Then place the wrapped records inside an album cover.
  9. Finally, label the outside of the album cover so you know which record belongs to which song.
  10. That’s it! Your vinyl records are now ready to play again.
  11. If you want to learn more about vinyl cleaning, check out our other guides here: How to Clean LPs & CDs

How to Clean Vinyl Records With Soap and Water?

If you prefer not to use rubbing alcohol to clean vinyl records, simply put soap and water on the surface and wash it as usual. This won’t damage your vinyl records, but it will leave a slight film on the surface which will make them appear dirty when stored.

Note: Don’t use anything too strong because it might cause the vinyl to warp.

  1. Pour some dishwashing liquid into a bowl or container.
  2. Use a soft brush or toothbrush to scrub the record gently.
  3. Rinse the record under running tap water and then pat it dry with a towel.
  4. Let the record sit for a few minutes to allow the dishwashing liquid to soak up any remaining dirt.
  5. Place the record back onto its original platters.
  6. Label the outside of the album covers so you know which record goes with which song.
  7. Store the albums in their sleeves.
  8. That’s all there is to it!

Conclusion

Vinyl records are a great way to preserve your favorite songs, but they can be tricky to clean if you don’t know what you’re doing. In this guide, we’ve shown you two different methods for cleaning vinyl records – one using rubbing alcohol and the other using soap and water. Both methods work well, but the latter is much faster and simpler. We hope you found this article helpful.

Click to rate this post!
[Total: 1 Average: 5]

Leave a Reply

Your email address will not be published. Required fields are marked *